Type K3G400-RJ75-01
Motor M3G112-EA
Phase 3~
Nominal voltage VAC 400
Nominal voltage range VAC 380 .. 480
Frequency Hz 50/60
Type of data definition ml
Speed min-1 2060
Power input W 1320
Current draw A 2.1
Min. ambient temperature °C -40
Max. ambient temperature °C 50
Mass 16.5 kg
Size 400 mm
Surface of rotor Coated in black
Material of electronics housing Die-cast aluminium
Material of impeller PP plastic
Material of support bracket Steel, coated in black
Material of inlet nozzle Sheet steel, galvanised
Number of blades 6
Direction of rotation Clockwise, seen on rotor
Type of protection IP 54
Insulation class “F”
Humidity class F4-1
Max. permissible ambient motor
temp. (transp./ storage) +80 °C
Min. permissible ambient motor
temp. (transp./storage) -40 °C
Mounting position Refer to product drawing
Condensate discharge holes Rotor-side
Operation mode S1
Motor bearing Ball bearing
Technical features – Output 10 VDC, max. 10 mA
– Operation and alarm display
– Alarm relay
– Integrated PID controller
– Motor current limit
– PFC, passive
– RS485 MODBUS RTU
– Soft start
– Control input 0-10 VDC / PWM
– Control interface with SELV potential safely disconnected from the mains
– Over-temperature protected electronics / motor
– Line undervoltage / phase failure detection
Touch current acc. IEC 60990
(measuring network Fig. 4, TN
system) <= 3.5 mA
Motor protection Thermal overload protector (TOP) wired internally
Cable exit Variable
Protection class I (if protective earth is connected by customer)
Product conforming to standard EN 61800-5-1; CE
Approval EAC
Size 400 mm
Surface of rotor Coated in black
Material of electronics housing Die-cast aluminium
Material of impeller PP plastic
Material of support bracket Steel, coated in black
Material of inlet nozzle Sheet steel, galvanised
Number of blades 6
Direction of rotation Clockwise, seen on rotor
Type of protection IP 54
Insulation class “F”
Humidity class F4-1
Max. permissible ambient motor
temp. (transp./ storage) +80 °C
Min. permissible ambient motor
temp. (transp./storage) -40 °C
Mounting position Refer to product drawing
Condensate discharge holes Rotor-side
Operation mode S1
Motor bearing Ball bearing
Technical features – Output 10 VDC, max. 10 mA
– Operation and alarm display
– Alarm relay
– Integrated PID controller
– Motor current limit
– PFC, passive
– RS485 MODBUS RTU
– Soft start
– Control input 0-10 VDC / PWM
– Control interface with SELV potential safely disconnected from the mains
– Over-temperature protected electronics / motor
– Line undervoltage / phase failure detection
Touch current acc. IEC 60990
(measuring network Fig. 4, TN
system) <= 3.5 mA
Motor protection Thermal overload protector (TOP) wired internally
Cable exit Variable
Protection class I (if protective earth is connected by customer)
Product conforming to standard EN 61800-5-1; CE
Approval EAC
